Slide Sledge Operating Manual

20 4. How To Use the Slide Sledge ™ Multi-Head ™ Hammer How to use the Slide Sledge ™ Multi-Head ™ Race/Bearing/Seal Drivers Slide Sledge ™ currently makes three sizes of driver adapters. These adapters allow users to attach their existing driver plates to the Slide Sledge ™ Multi-Head ™ hammer. Shown without drive plate Shown with drive plate (not included) Shown without drive plate Shown with drive plate (not included) 2.Race/Bearing/Seal Adapter #25321 / 213526 —Install races, bearings, and seals with this adapter driver tip. Add drive plates to the end of the adapter in various combinations. This adapter fits plates with a common 9/16" center hole, up to 3/4" high. The drive plates are not included. 3.Bushing Driver Adapter #25322 / 213527 —Proper installation of bushing will be accomplished easily and quickly with this adapter driver tip. Fits drivers with a common 3/4" center hole, up to 7/8" high. The drive plates are not included. WARNING: Always refer to the original equipment manufacturers’ procedures for installation or removal of equipment. Follow all manufacturers’ safety procedures. Shown without drive plate Shown with drive plate (not included) 1.Bushing/Bearing/Seal Plate Driver #25320 / 213525 —Use the extreme power of the Slide Sledge ™ Multi-Head ™ to drive heavy duty plates without the cocking motion of a hammer and handle. This adapter fits plates with a 1/4" center hole. The drive plates are not included.